User`s manual

Chassis Plans CPPM-8U201 Technical Reference – ‘A’ & ‘D’ Controller
Page 9
‘A’ and ‘D’ OSD
The CPPM-8U201 provides for On Screen Display (OSD) of the controls to adjust the display parameters such as
brightness, contrast, etc. The display controller stores the settings in non-volatile memory so they are saved even
when power is turned off or removed.
To enter the OSD, press the front panel Menu/Select button. Then use the Left/Decrease and Right/Increase
buttons to scan between each of the menu choices. When the desired menu item is selected, again press
Menu/Select to either bring up the control bar or the underlying sub menu.
If a control bar is brought up, use the Right/Increase or Left/Decrease buttons to change the level. Press
Menu/Select to accept the change or simply press Auto/Exit to accept the change and exit that menu.
If a sub menu is brought up, use the Left/Decrease and Right/Increase buttons to navigate the sub menu and
again use Menu/Select to change to the next menu or control.
Repeatedly pressing Auto/Exit will eventually exit the OSD or you can wait the number of seconds the OSD Timer
is set for to automatically exit the OSD.
Note in the Main Menu, the current resolution, horizontal and vertical frequencies are displayed. The bottom of the
Main Menu shows the controller firm ware revision.
OSD Main Menu
The main OSD menu is shown below.
Brightness Underlying bar control to adjust the display brightness
Contrast Underlying bar control to adjust the contrast or distinction of the display.