User's Manual

14. Type-c interface: Direct connection with mobile phone/tablet device
15. HDMI Socket：1080P HD image real-time output
16. Tether Connection Socket/Charging socket.
17. Phone/Tablet Clamp：Used to attach phone/tablet mount to mounting bracket.
18. Clamp Button：Pull apart the two ends and put in the phone/tablet, then press this button to tighten.
Note: Do not put the controller in the water to avoid damaging the device, damages caused by water ingress are not covered by the
warranty.
Handle indicators introduction
Battery：
Red：10%↓ Red light flashes quickly；10-29% Red light always on.
Blue：30-69% Blue light always on；
Green：70-100% Green light always on;
Signal Indicator
a 2.4G：2.4Ghz Wi-Fi indicator，always on when working.
b 5G：5Ghz Wi-Fi indicator，always on when working.
c ROV：Indicates the communication status between the controller and the ROV (Steady light indicates successful connection,
Blinking light indicates disconnection.)
Gesture back Button：
The blue light is always on when the ROV is in a non-horizontal position
Unlock Button：
Locking: No lights
Unlocking: Blue light on
Led Control Button：
Bright light：Blue light always on;
Low light: Blue light flash;
No light: Blue light off.
100/200 meters Tether & Winder
The tether is used to connect the drone and the remote controller
The winder is used to store the tether.
1. Tether connectors
2. Tether
3. Winder
4. Fastener
Warning：
a. Do not put exposed (unconnected) tether into the water or plashing liquid to the tether.
b. Check whether the O-ring on the tether connector pre-dive, make a replacement when it is missed or damaged.