User's Manual

FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operat
e
the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
ISEDC RSS warning
This device complies with Innovation, Science and Economic Development Canada Compliance licence-exempt RSS standard (s).
Operation is subject to the following two conditions:
(1) this device may not cause interference,
and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement
SAR tests are conducted using standard operating positions accepted by the FCC/ISEDC with the device transmitting at its highest
certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR
level of the device while operating can be well below the maximum value.
Before a new model device is a available for sale to the public, it must be tested and certified to the FCC/ISEDC that it does not exceed
the exposure limit established by the FCC/ISEDC, Tests for each device are performed in positions and locations as required by the FCC/
ISEDC.
For limb worn operation, this device has been tested and meets the FCC/ISEDC RF exposure guidelines when used with an accessory
designated for this product or when used with an accessory that contains no metal.
For body worn operation, this model device has been tested and meets the FCC/ISEDC RF exposure guidelines when used with an
accessory designated for this product or when used with an accessory that Contains no metal and that positions the handset a minimum of
1 cm from the body.
Non-compliance with the above restrictions may result in violation of RF exposure guidelines.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
Tous les changements ou modifications non expressément approuvée par le responsible de la conformité pourrait vider l’utilisateur est
habilité à exploiter l’équipemen.