User guide

NetWare configuration
Page 76
Chapter 2 Installation and Configuration
Configuration Methods
To support the widest possible range of users, the IOPRINT+ Print Server is supplied with the
following utilities.
For information on using each of these methods, select the desired document from the list
below.
• Appendix A BiAdmin Management Program
• Printing - NDS & Bindery
• Appendix B PSConfig
For information on Server and Client configuration for NDPS, and using NDPS for printing,
see the following document. Printing - NDS & Bindery.
Item Description
BiAdmin If possible, you should use the supplied BiAdmin utility for configuration
BiAdmin is a powerful, user-friendly program which runs under
Windows 95/98/NT.
If you have Novell NetWare Client 32 for Windows installed, BiAdmin
also allows you to configure the NetWare server for Bindery and NDS
operation.
Quickset QUICKSET is a DOS-based command-line program, designed for the
fastest possible setup of both the NetWare server and the IOPRINT+
Print Server. Both Bindery and NDS are supported
The QUICKSET program will configure the IOPRINT+ Print Server and
the current Novell server in a single operation. However, it provides few
options.
PSConfig PSConfig is a DOS-based, menu-driven program. It uses the IPX/SPX
protocol to connect to the IOPRINT+ Print Server, so your PC must load
the IPX/SPX drivers before PSConfig can be used.
PSConfig can only configure the IOPRINT+ Print Server itself. You must
use the NetWare's PCONSOLE or NWAdmin to configure the NetWare
server. To create or modify NetWare printer objects and printer queues,
and allow user groups to access those queues, use PCONSOLE.