User guide

Unix - TCP/IP
Page 53
Chapter 2 Installation and Configuration
Using RARP 1. Perform steps 1. to 3. for assigning a static IP Address.
2. If the rarp daemon is not running, start it with the command:
rarpd -a
3. Add a line to the Ethernet Address table /etc/ethers
00:c0:02:xx:yy:zz NAME
Where
00:c0:02:xx:yy:zz is the physical address of the IOPRINT+ Print Server
NAME is the name of the IOPRINT+ Print Server.
4. Reset the IOPRINT+ Print Server. When it reboots, it should acquire an IP Address from
rarp.
5. If the IOPRINT+ Print Server is not configured yet, you can now configure it using FTP.
Otherwise, check the Address with the ping command:
ping NAME
You should receive a response. If you get a Timeout message, the above procedure has
failed.