User guide

Unix - TCP/IP
Page 47
Chapter 2 Installation and Configuration
IP Address Configuration
The IOPRINT+ Print Server requires the following IP Addresses to be entered.
(The entry in brackets shows the line number and token in the device's configuration file. This
information is for people using FTP.)
Device IP Address Normally, the IOPRINT+ Print Server is assigned a static IP Address. If you leave its IP
Address at the default value of 0.0.0.0, its sequence for finding an IP Address dynamically is
as follows:
DHCP, BOOTP, RARP.
See Dynamic IP Address Configuration on page 52 for more details.
Item Description
IP Address
(4000 IP_ADDR)
Device IP Address. See the following
section.
Gateway Address
(4001 GATEWAY)
If your network segment has a router,
enter the router address here.
If there is no router, leave the address
as 0.0.0.0.
Subnet Mask
(4002 MASK)
If the Gateway Address above is
0.0.0.0 the Subnet Mask should also
be left at 0.0.0.0.
If you have a router, enter the Subnet
mask for the segment to which the
IOPRINT+ Print Server is attached.