User guide

AppleTalk Configuration
Page 41
Chapter 2 Installation and Configuration
Printing
Printing with the IOPRINT+ Print Server installed in an AppleTalk network is identical to
normal printing.
For example, select a document that you want to print and then select File - Print. Chose the
desired printer.
Advanced Setup and Management
This section describes the configuration changes which can be made to your IOPRINT+ Print
Server device.
Changing the Device Configuration - Windows Software
In a mixed Windows PC/Macintosh environment, you can use either WPConfig or BiAdmin to
configure the IOPRINT+ Print Server.
Changing the Device Configuration - Macintosh Software
In AppleTalk, you can use SimpleText to edit the IOPRINT+ Print Server's CONFIG file and
the supplied PSTool program to send it to the IOPRINT+ Print Server. The procedure is as
follows:
1. Navigate to the Utility\Apple folder on the CD-ROM.
2. Copy the file "PSTool" to an appropriate folder on your hard disk.
3. Select the appropriate CONFIG file for your model, and copy it to your hard disk. The
CONFIG files are as follows:
config.1p - Single parallel port model
config.2p1s - Two parallel ports, 1 serial port
config.3p - Three parallel ports
4. Use Chooser to select the desired IOPRINT+ Print Server.
5. Double click the CONFIG file, and edit it. The file should look like the example below, but
may vary depending on your model. The appropriate values for each line are described in
the following section.