User guide

Initial configuration
Page 34
Chapter 2 Installation and Configuration
9. Check the Power and Status LED indicators on the top of the unit. When the Red Status
indicator LED goes out and the Green Power indicator LED remains lit or flashes, the
IOPRINT+ Print Server is ready.
10.If desired, use Velcro adhesive strips to attach the IOPRINT+ Print Server unit to the side
of a laser printer to conserve working space.
Initial configuration
This section describes how to configure your IOPRINT+ unit following installation.
The IOPRINT+ Print Server is designed to support many different platforms, and the
configuration required will depend upon the environment in which it is installed. Depending
upon the situation, any or all of the following may require configuration:
• IOPRINT+ Print Server device.
• LAN Server.
• Client PCs on the LAN.
Following configuration, you can use a number of utilities to perform management tasks. See
Management on page 36 for details.
This section includes the following:
• Windows Users on page 34
• Configuration Procedure on page 35
Windows Users
If you are running Windows 95/98, or Windows NT, use the SETUP program in the
appropriate directory on the CD-ROM.
This will allow you to install the manual and the BiAdmin configuration/management
program.
• For details regarding configuration for your particular situation, see the list of documents
below.
• For details about the BiAdmin utility and other management utilities provided with your
IOPRINT+ Print Server, see the following Management section.
Warning
Use only the Power Supply unit provided with the device.
Power Supply units for different models are not
interchangeable.