User guide

IOPRINT+ Print Servers User guide
IOPRINT+Jr FAST
Page 30
Chapter 1 Introduction
LED Indicators
There are two LED indicators on the top on the IOPRINT+Jr FAST
The LED indicator modes are described in the following table.
10/100BaseT DIP Switches
The 2 DIP switches are used to determine the operating mode. Their function is as follows.
LED Function
Green Power/Link indicator
Red Status/Error indicator
Green LED Red LED Status description
Solid Off Solid Off No power.
Solid On Solid On Hardware error.
Solid On Solid Off Normal operation.
Flashing Off Transmitting or receiving packets from the network.
Switch Function Details
1 Auto Negotiation Switch When ON (UP position), the device
will select 10BaseT/100BaseT and
Full/Half Duplex as required. The
recommended position is ON;
switches 2 & 3 are disabled when
Auto Negotiation is ON.
2 10/100BaseT Manual Select Switch Set UP for 100BaseT or DOWN for
10BaseT.
Switch 1 must be OFF for this
switch to function.
3 Full/Half Duplex Switch Set UP for Full duplex operation or
DOWN for Half Duplex
operation.Switch 1 must be OFF for
this switch to function.