User guide

IOPRINT+ Print Servers User guide
Printing problems
Page 293
Printing by FTP, I receive an error
message:
Invalid print queue
Print queue not ready
1. Check that the printer is ready
2. Check that Logical printer(s) are defined on the
IOPRINT+ Print Server. With FTP, you can print ONLY to
a logical printer.
Reset the IOPRINT+ Print Server
I can't print using LPD. Try printing with FTP. If this works, the problem is the LPD daemon
on your UNIX host. Reconfigure the remote printer and the LPD
daemon. Check the following points.
• The remote host name is the name of the IOPRINT+ Print
Server.
• The remote printer name is the logical printer name on the
IOPRINT+ Print Server (e.g. L1).
• If your UNIX asks for the LPD type, be sure to identify the
service type as BSD.
I can't print using PSfilter, 1. Run PSfilter directly with the command:
PSfilter -D P_name -v <file_name&
Where:
P_name is the IOPRINT+ Print Server's name
file_name is the file you wish to print.
2. If this fails, check for an error log file (e.g. PSErrLog
XXXXX) in the /tmp directory. If there is not an error log
file, recompile PSfilter.
Also, check the Troubleshooting section of the Psfilter
.TXT file for your system.
The "String Before Job" and/or
"String After Job" settings in the
Logical Printers don't work
properly
1. Check the length of the control strings. No string can
exceed 15 characters.
2. Check that the control strings are in HEX.
Problem Solution