User guide

IOPRINT+ Print Servers
Using FTP
Page 269
Commands
Only the following commands are implemented. Commands are usually case sensitive.
Where the command requires a parameter, the parameter is shown in italics.
dir - List files (as shown in the previous table).
get FILENAME - Retrieve a file. The only files that can be retrieved are CONFIG and
PSINF. Using GET with the other "files" will activate a command, as follows:
put CONFIG - Copy the file CONFIG to the device, overwriting the existing CONFIG file.
Details of the format of CONFIG files are contained in Appendix B - Configuration File
Format.
put PASSWORD - Copy the file PASSWORD to the IOPRINT+ Print Server, giving it a
new password. Passwords can be up to 19 bytes in length.
put filename Ln - Copy the file filename to the printer connected to Logical Port n, where
n is a Logical Port number. This will print the file.
quit - Terminate the current FTP session.
Other FTP Commands - The other FTP commands are not implemented, and will usually
return the error message Invalid command.
Item Description
get DEFAULTC Set the IOPRINT+ Print Server back to its default
configuration.
get RESET Reset the IOPRINT+ Print Server. This also
terminates the current connection.
get PASSRESET Clear password (no password).
get SETIP Set the current IP address as a static IP address.
Warning
Do NOT use the SETIP command if the device has an IP
Address assigned by a DHCP server. This will cause an
Address conflict
Note
After using the put CONFIG command to write a new configuration file to the device,
you should issue a get RESET command.