User guide

IOPRINT+ Print Servers
Introduction
Page 215
Introduction
The 100BaseT IOPRINT+ Print Server models incorporate a HTTP server. This allows you to
connect to the IOPRINT+ Print Server and configure it using your Web Browser. Most
browser should work, provided they support tables and forms.
Preparation
Because it supports dynamic IP Address allocation using DHCP, BOOTP, or RARP, the
IOPRINT+ Print Server ships with an IP Address of 0.0.0.0. This is NOT a valid IP Address.
Therefore, you must do one of the following:
• Check your DCHP server (if you have one), and determine the IP Address allocated to the
IOPRINT+ Print Server. (Note: The physical address of the IOPRINT+ Print Server can be
determined from the Default Name shown on a sticker on the base in the form SCxxxxxx,
where each x represents a digit The physical address is 00:c0:02:xx:xx:xx.)
• Configure the Unix
or Windows NT host so that you can connect to the IOPRINT+ Print
Server and allocate an IP Address to it.
• Use BiAd min
or another method to allocate a valid IP Address to the IOPRINT+ Print
Server.
Connecting to the IOPRINT+ Print Server
1. Start your Web Browser
2. In the Address box, enter HTTP:// followed by the IP Address of the IOPRINT+ Print
Server.
e.g.
http://192.168.0.21
3. You will then be prompted for the password. If no password has been set, just press
ENTER.
4. Use the menu bar on the top of the screen to move about. Remember to save each
screen before changing to a different screen.