User guide

IOPRINT+ Print Servers
Configuration options
Page 210
Configuration options
These options allow you to configure the current IOPRINT+ Print Server.
Option Details
System Allows you to change the device name, and to set the LAN
protocol(s) used by the current device. Only the Connected Protocol
referred to on page 64, and your LAN protocol, should be enabled.
Note that by default, all protocols are enabled. This allows operation
in any environment, but degrades performance.
Netware Configure NetWare with this icon.
TCP/IP Use Settings -IP Addresses to initially assign an IP address, and this
button for any subsequent changes.
AppleTalk Enter AppleTalk configuration details here.
NetBEUI Allows NetBEUI (Windows SMB) changes to be made. The available
fields are as follows:
Domain name Enter the designated work group to be serviced by the IOPRINT+
Print Server. Using only UPPER CASE is recommended.
Response Time Sets how fast jobs are sent to the printer. The default value of zero (0)
delay should be increased only if your printer cannot cope with no
delay.
Abort Job As
Paper Out
YES will terminate the current print job when a printing error is
encountered. NO (default) will try to continue but may cause print
errors. If errors occur, try setting this value to YES.
Note
Normally, there should be no need to adjust these settings.
Serial Port Configure the serial port if one is fitted. Check your serial printer to
see what settings should be used.
Logical Port Logical ports (printers) can be used under NetWare or Unix.
SNMP Enter SNMP configuration data here.