User guide

IOPRINT+ Print Servers
Using PSConfig - NDS Mode
Page 201
Remote Printer Mode - Configuration Procedure
In remote printer mode the following assignments should be used, where SCxxxxxx is the
device name.
Ensure that you are in the NDS mode then follow the steps listed below.
Create queue objects
1. Login to NetWare as ADMIN. or a user with Admin. rights.
2. Run the PCONSOLE program.
3. Select Print queues.
4. Press INS key to add a new queue.
5. Type a queue name, and press Enter.
Repeat Steps above until you have the desired number of queues.
Create printer objects
1. From the PCONSOLE Main Menu, select Print servers.
2. Select a NetWare Print Server.
3. Select Printers
4. Press INS Key to insert a printer.
5. Enter the correct information in the Name Field. Refer to the previous section Remote
Printer Asssignments.
6. Select the printer.
7. In the Type field, select parallel for parallel port 1, 2, or 3; select serial for the serial port.
8. Select Configuration
9. In the Port field, select LPT1 for parallel port 1, LP2 for parallel port 2, LPT3 for parallel
port 3, and COM1 for the serial port.
10.In Location field, set to Manual Load.
11. Press Esc to exit Configuration sub-menu.
Device
Port
NetWare
Printer Type
Printer Name
Parallel 1 Remote Parallel, LPT1 SCxxxxxx
Parallel 2 Remote Parallel, LPT2 SCxxxxxx_P2
Parallel 3 Remote Parallel, LPT3 SCxxxxxx_P3
Serial Remote Serial, COM1 SCxxxxxx_SP