User guide

IOPRINT+ Print Servers
Using PSConfig- NetWare Bindery Mode
Page 194
Attach to more than one NetWare Print Server (Remote Printer Mode)
If you used QUICKSET to configure your IOPRINT+ Print Server in NetWare Remote Printer
mode, the setup uses the same NetWare Print Server for each port.
If you want each port of the IOPRINT+ Print Server to attach to a different NetWare Print
Server, perform the following steps.
1. Use PCONSOLE to create and assign the required printers and queues as required.
2. Run PSCONFIG
3. Select the correct IOPRINT+ Print Server
4. Select Set to NetWare Remote Printer Mode.
5. Enter the correct NetWare print server names in the print server name fields, for P2
(Parallel Port 2), P3 (Parallel Port 3), and SP (Serial Port), as appropriate.
6. Select Execute Setup to save your changes.