User guide

IOPRINT+ Print Servers
Using PSConfig- NetWare Bindery Mode
Page 188
Procedure - NetWare V2, V3
Follow the steps listed below to configure the IOPRINT+ Print Server in NetWare print server
mode for NetWare V2, V3, or V4 (Bindery Mode):
Create Queues. 1. If using existing queues, log in and proceed to Step 2. Otherwise, perform the following
procedure.
a. Log into a NetWare file server as a SUPERVISOR or as a user with SUPERVISOR
rights.
b. Run PCONSOLE program.
c. Select Print Queue Information.
d. Press [Ins] key to add a new queue.
e. Type a queue name, and press [ENTER].
f. Repeat until you have the desired number of queues.
Add a Novell Print
Server.
2. Follow these steps to inform NetWare that a print server exists.
a. From the PCONSOLE Main Menu, select Print Server Information
b. Press [Ins] to add a new print server.
c. Enter your desired print server name.
Assign Printers. 3. Follow these steps to associate the NetWare printer objects with the IOPRINT+ Print
Server's printer ports.
a. Select the Print Server just added.
b. Select Print Server Configuration.
c. Select Printer Configuration.
d. Select the print number, using the correct printer numbers.
e. Press [Esc].
f. Select YES.
g. Repeat steps d) to f) for each printer port.
Associate printers
with Print Queues.
4. Follow the steps below to associate print queues with the printer(s) attached to the
IOPRINT+ Print Server.
a. Select Queues Serviced by Printer from the Print Server Configuration Menu.
b. Select the printer to which you want to assign a print queue.
c. Press [Ins], then select the queue that you want the printer to service.
d. Press [Enter] twice to associate the printer with the queue.
e. Repeat until all printer and queue associations are completed.
f. Exit PCONSOLE