User guide

IOPRINT+ Print Servers
Using PSConfig- NetWare Bindery Mode
Page 182
Using PSConfig- NetWare Bindery Mode
PSConfig is a DOS-based, menu-driven program. It uses the IPX/SPX protocol to connect to
the IOPRINT+ Print Server, so your PC must load the IPX/SPX drivers before PSConfig can
be used.
PSConfig can only configure the IOPRINT+ Print Server itself. You must use the NetWare
PCONSOLE program to configure the NetWare server. To create or modify NetWare printer
objects and printer queues, and allow user groups to access those queues, use PCONSOLE.
• Installation on page 183
• Using PSConfig on page 183
• Configuration Data on page 184
• IOPRINT+ Print Server Data on page 185
• Configuration - Print Server Mode on page 187
• Novell Remote Printer Mode on page 191
• Printer assignments (remote printer mode) on page 197
• Configuration - Remote Printer Mode on page 191
• Advanced Configuration on page 193
Note
If possible, use the BiAdmin management utility instead. BiAdmin will allow you to
configure both the IOPRINT+ Print Server and the NetWare server. BiAdmin
requires Windows 95/98/NT.