User guide

Windows Peer-to-peer - TCP/IP
Page 119
Chapter 2 Installation and Configuration
Items shown on this screen are as shown in the next table.
7. Change the port name if you wish, and set the banner options.
8. Configure the Printer to use this new port:
a. Go to Start-Settings-Printers. Invoke the Add Printer Wizard.
b. Select the Local printer option.
c. Choose the Printer which is attached to the first port on the IOPRINT+ Print Server.
d. In the Available Ports screen, shown below, select the Port Name (from step 5) as
the port to use.
e. If you click the Configure Port button, you will see the Configure Print Server
screen again.
Item Description
Device Name Click Browse and select the correct IOPRINT+ Print Server. The
name shown will be in the form SCxxxxxx (SC followed by 6
digits), as shown on a label on the base of the IOPRINT+ Print
Server. The name can be changed if you wish, but it is only visible
when configuring the device.
Select Device Port Select the IOPRINT+ Print Server port that the printer is
connected to (e.g. Parallel port 1).
Port Name On multi-port devices, each port must have a unique name (8
alpha-numeric characters). The Port Name will be shown in the
Printer's properties. Use a name which indicates the port used
(e.g. Par_1)
Enable Banner Select this option to enable a banner page.
PostScript If using a PostScript Printer, check this box.
User Name The name to be printed on the banner page.
Retry Interval Sets how often Windows will poll the IOPRINT+ Print Server to
establish a connection when the printer is busy. Values range from
40-110 seconds.