User guide

Windows Peer-to-peer - TCP/IP
Page 117
Chapter 2 Installation and Configuration
Device Configuration
The IOPRINT+ Print Server must be configured with the following IP Addresses before it will
be recognized as a valid device on your LAN.
Procedure When you install the software and select TCP/IP as the protocol, you will have the option of
installing a program called SETBOX. This program can be used to assign the above IP
Addresses to the IOPRINT+ Print Server, as follows:
1. If SETBOX is installed, it will automatically run.
2. Select your IOPRINT+ Print Server. It will be shown in the form SCxxxxxx (SC followed by
6 digits). This name is on a label on the base of the device.
3. Enter and save the IP Addresses listed above.
This procedure only needs to be done ONCE. When installing on other PCs, do NOT install
SETBOX.
Item Description
Device IP Address Assign a unique IP Address to the IOPRINT+ Print Server.
The address must be from the same address range as PCs
on your LAN.
Gateway IP Address Use the same Gateway Address as your PC.
Subnet Mask Use the same Subnet Mask as your PC.
Note
You can start the WINIPCFG program from the Run dialog to check the
IP Address, Gateway Address, and Subnet Mask on your PC.