User guide

Windows Peer-to-peer - SMB
Page 115
Chapter 2 Installation and Configuration
Windows for Workgroups
1. Start Control Panel- Printers.
2. From the list of Installed Printers, select the printer driver for the printer attached to the
first port on the IOPRINT+ Print Server.
If the printer driver is not installed, click Add>> to install a new driver.
3. If desired, click "Set As Default Printer".
4. Click "Connect..." to open the Connect dialog box.
5. Click "Network...
6. In the Path field, enter the name and port of the IOPRINT+ Print Server in the following
form:
\\Name\Port
Where:
Name is the name of the IOPRINT+ Print Server device. If you have not changed the
name, use the default name shown on the base. The default name is in the form
SCxxxxxx (SC followed by 6 digits).
Port is the port on the IOPRINT+ Print Server to which the printer is attached. The port
must be P1 (parallel port 1), P2 (parallel port 2) or P3 (parallel port 3, or the serial port).
e.g.
\\SC123456\P1
7. Check the Reconnect at Startup box, then click OK to close the Connect Network Printer
dialog box.
8. Click "OK" to close the Connect dialog box.
9. Repeat steps 2 to 8 for any additional ports on the IOPRINT+ Print Server. Close the
Printer Dialog when your are finished.
Configuration is now complete. You will be able to print to the printer attached to the
IOPRINT+ Print Server by selecting the printer you just installed.
Printing
Once configured, printing to the printers attached to the IOPRINT+ Print Server is the same
as printing with the printer attached directly to your local LPT port.
Simply select File-Print. When the Print screen appears, select the appropriate printer and
options and click OK.