User guide

Windows Peer-to-peer - SMB
Page 114
Chapter 2 Installation and Configuration
Windows 95/98/NT
1. Start the "Add Printer" Wizard.
2. When prompted, "How is the printer attached to your computer?", select "Network
Printer".
3. When prompted for "Network path or Queue name", enter the name and port of the
IOPRINT+ Print Server in the following form:
\\Name\Port
Where:
Name is the name of the IOPRINT+ Print Server device. If you have not changed the
name, use the default name shown on the base. The default name is in the form
SCxxxxxx (SC followed by 6 digits).
Port is the port on the IOPRINT+ Print Server to which the printer is attached. The port
must be P1 (parallel port 1), P2 (parallel port 2) or P3 (parallel port 3, or the serial port).
e.g.
\\SC123456\P1
4. Select the printer connected to the port on the IOPRINT+ Print Server.
5. Finish installing the printer as usual. In Windows NT, do NOT enable sharing on this
printer.
If your IOPRINT+ Print Server has multiple ports, install the other printers in the same
manner, but using a different IOPRINT+ Print Server port.
Configuration is now complete. You will be now able to print to the printer attached to the
IOPRINT+ Print Server by selecting the printer you just installed.
Note
The "Browse" button can be used ONLY IF the IOPRINT+ Print Server has a "Workgroup
Name" (in the NetBEUI configuration) which is the same as your computer's "Workgroup
name".