User guide

Windows Peer-to-Peer - NetBEUI
Page 102
Chapter 2 Installation and Configuration
1. Configure the Printer to use this new port
a. Go to Printer Manager. Select Printer- Create Printer.
b. Select the appropriate printer driver for the printer connected to the first port on the
IOPRINT+ Print Server.
c. In the Print to dialogue box, select the port name you assigned to the IOPRINT+
Print Server port previously in this procedure.
d. If you click on Settings, you will see the Configure Print Server window again.
2. Follow the on-screen instructions to finish adding a printer as normal. Do NOT click the
Share This checkbox for this printer.
3. You can now print using this printer.
Item Description
Device Name Click Browse and select the correct IOPRINT+ Print
Server. The name shown will be in the form SCxxxxxx
(SC followed by 6 digits), as shown on a label on the
base of the IOPRINT+ Print Server. The name can be
changed if you wish, but it is only visible when configuring
the device.
Select Device Port Select the IOPRINT+ Print Server port that the printer is
connected to (e.g. Parallel port 1).
Port Name On multi-port devices, each port must have a unique
name (8 alpha-numeric characters). The Port Name will
be shown in the Printer's properties. Use a name which
indicates the port used (e.g. Par_1)
Enable Banner Select this option to enable a banner page.
PostScript If using a PostScript Printer, check this box.
User Name The name to be printed on the banner page.
Retry Interval Sets how often Windows will poll the IOPRINT+ Print
Server to establish a connection when the printer is busy.
Values range from 40-110 seconds.