User guide

IOLAN+, IOLAN+ Rack & IOLAN+ 102/104 User guide
Configuration
Page 81
Chapter 6 Dialout modem ports setup
Configuration
The Port Setup Menu should be set up as follows for both simple dial-in connections and
PPP/SLIP connections.
The following fields are important:
Field Description
Access Set the Access field to Dynamic (dial-in or out) or Remote (dial-
out only).
Monitor DCD With this flag set to Yes, the terminal server will monitor the
modem signal Data Carrier Detect (DCD) - pin 8. When the
modem hangs up, pin DCD from the modem goes low and the
terminal server port will reset.
Flow Ctrl The modem and terminal server port should be configured to
use Hardware (RTS/CTS) flow control. This will be especially
important if you are transferring binary files.
Mode Set this field to raw.