User guide

IOLAN+, IOLAN+ Rack & IOLAN+ 102/104 User guide
Command descriptions
Page 169
set
Syntax: set <parameter> [value], etc.
Description: The set command allows the administrator to configure any of the IOLAN+ parameters. It
also allows the user to alter their own set-ups and change terminal type. Admin level is
required on most functions.
set admin
Syntax: set admin
Description: This function allows the user to become the administrator or admin level. The command su
can also be used.
set menu
Syntax: set menu
Description: This function sets the user’s port into menu mode, assuming that the term type has been set.
set modem
Syntax: set modem
Description: This function transmits a series of modem initialisation commands to the attached modems.
A sequence of port numbers from 1 upward can be given or all to indicate all serial ports. The
modem commands are taken from the Modem Config field of the Remote site devices menu.
set term
Syntax: set term
Description: This function allows a user to alter their terminal type. If the term field is left blank the
IOLAN+ displays a list of all the currently supported terminals (ansi, dumb, vt100, wyse50,
wyse60, tvi925, ibm3151, vt320, falco, hp700).