Product specifications

123
Troubleshooting & Maintenance
1. Self-test
2. Diagnostics
3. Monitor
4. Download
5. Reset
q. Quit and boot server firmware
Self-test
This is for troubleshooting with Chase support only. It runs a
signal level check on every port (and requires loopbacks on
all ports). It also performs the Ethernet and RAM test (as in
the diagnostics).
Diagnostics
This option will run a set of hardware diagnostics tests. If
you get any errors report them to your supplier or Chase
support. There are three options:
a. Serial ports: You will need a loopback
connector to run this test (provided with the
unit). Put it on the suspect port.
b. Ethernet interfaces:
This option allows you to
test the Ethernet ports. You will need Ethernet
loopbacks. 10BASE-T is provided, for 10BASE5
use a MAU, and for 10BASE2 use a T-connector
with two terminators. Connect suspect loopback.
c. Memory/RAM test: This option tests the RAM
of the unit and reports any faults. The test takes
about 1 minute to complete.
Monitor
This is for troubleshooting with Chase support only.
Download
It allows firmware to be downloaded via port 2 or an
Ethernet interface via TFTP.