User Instructions

SOOT DOORS

PRE LIGHTING CHECK

COMMISSIONING

It is possible to pass a 16 inch diameter sweep’s brush through the

appliance but in most back outlet installations it will be necessary to

have a soot door to enable the chimney to be swept. The optional

vertical rear flue connector does allow the chimney to be swept

through the stove.

Soot doors may either be in the actual brickwork of the chimney or

in the register plate. Various positions of soot doors are shown in

Figs. 5 to 8.

Ensure that the throat plate is fitted in the roof of the appliance. The

location and positioning of the throat plate is shown in Fig. 3.

Check that the front fence is fitted correctly and that the door closes

properly.

On completion of the installation allow a suitable period of time for

the fire cement and mortar to dry out before lighting the fire. If no

grate is fitted, make a layer of ash or sand on the base of the stove

before lighting. Check to ensure that smoke and fumes are taken

from the appliance up the chimney and emitted safely. Also check all

joints and seals. On completion of the installation and commissioning

please leave the operating instructions with the customer and advise

them on the use of the appliance.

INSTALLATION INSTRUCTIONS

With Soot Door

Alternative

Soot Door Positions

Fig. 8. Horizontal Register Plate With Optional

Vertical Rear Flue Connector

charnwood