® charnwood country 4 MKII Operating & Installation Instructions
CONTENTS O P E R AT I N G I N S T R U C T I O N S Fuel 4 Fitting The Riddling Grate 4 Lighting 5 Controlling The Fire 5 Refuelling 5 Ash Clearance 6 Reduced Burning 6 Cleaning and Maintenance 6 Throat Plate & Flueway Clearing 6 Chimney Sweeping 6 Servicing 7 Trouble Shooting 7 CO Alarm 8 If you need further help 8 INSTALLATION INSTRUCTIONS Health & Safety Precautions 10 CO Alarms 10 Specification 10 Chimney 10 Hearth & Fire Surround 10 Connection to Flues 11 Soot Door
charnwood OPERATING INSTRUCTIONS ® Before lighting the stove check with the installer that the work and operating appliance for burning dry seasoned wood logs only. HETAS checks described in the Installation Instructions have been carried out approval does not cover the use of other fuels either alone or mixed correctly and that the chimney has been swept, is sound and free with wood logs nor does it cover the instructions for use of other from any obstructions.
charnwood OPERATING INSTRUCTIONS ® CONTROLLING THE FIRE Fig.2. Optional Grate Kit The rate of burning and hence the output is controlled by the spin wheel and the airwash control (see Fig. 1). Grate Plates The spin wheel should only be used when lighting or when rapid Fuel Retainer burning is required. It should not be left fully open for long periods as this can cause over-firing. For low burning it should be closed.
charnwood OPERATING INSTRUCTIONS ® the grate bars. The ashpan is handled using the tool provided. Care deposits on the glass may be removed with a proprietary stove glass should be taken to ensure that ash is cool before emptying it into cleaner or ceramic hob cleaner. Do not use abrasive cleaners or pads plastic liners or bins.
charnwood OPERATING INSTRUCTIONS ® mm (0.10 inches) water gauge (25Pa) should be obtained. seals are in good condition and that the door seals correctly. A servicing guide is available on request. Repairs or modifications may Some blackening of the glass may occur below the level of the coal only be carried out by the Manufacturer or their approved agents. retainer. This will not obscure the view of the fire or affect its Use only genuine Charnwood replacement parts. performance.
charnwood OPERATING INSTRUCTIONS ® CO Alarm Your installer should have fitted a CO alarm in the same room as the appliance. If the alarm sounds unexpectedly, follow the instructions given under “ Warning Note” abo ve. IF YOU NEED FURTHER HELP If you need further help with your Charnwood then your Installer will be able to provide the answers to most questions. Your Local Charnwood Premier Dealer has a great deal of experience and will also be able to provide helpful advice.
charnwood INSTALLATION INSTRUCTIONS ® HEALTH AND SAFETY PRECAUTIONS the stove to the top of the chimney. The internal dimensions of the chimney should preferably be 175 mm (7 inches) or 200mm (8 Please take care when installing the stove that the requirements of inches) either square or round and MUST NOT BE LESS THAN 150 the Health and Safety at Work Act 1974 are met. mm (6 inches).
charnwood INSTALLATION INSTRUCTIONS ® Fig. 5. Vertical Register Plate With Bricked Up Fireplace Fig. 4. Flue Blanking Plate. Back of the Stove Blanking Plate Soot Door In Side or Rear Of Chimney Register Plate Blanking Plate Clamping Plate with fold horizontal Clamping plate finishes flush with inside face of firebox top and bottom. Fig. 6. Horizontal Register Plate With Rear Flue Connection Seal Blanking Plate with fire cement Alternative Soot Door Positions sufficient air circulation.
charnwood INSTALLATION INSTRUCTIONS ® Fig. 8. Horizontal Register Plate With Optional Vertical Rear Flue Connector Alternative Soot Door Positions Register Plate With Soot Door SOOT DOORS It is possible to pass a 16 inch diameter sweep’s brush through the appliance but in most back outlet installations it will be necessary to have a soot door to enable the chimney to be swept. The optional vertical rear flue connector does allow the chimney to be swept through the stove.
charnwood COUNTRY 4 DIMENSIONS (mm) ® 140 i/d to suit 125mm (5") flue pipe 416 110 50 545 589 308 487 437 399 240 386 242 33 261 92 87mm Dimensions of the Optional Vertical Rear Flue Connector 168mm 13
charnwood COUNTRY 4 PARTS LIST ® Issue N 29 7 25 12 20 11 21 10 27 15 28 9 16 Optional Coal Kit 11 8 31 33 34 32 32a 37 30 35 38 22 Item 1* 2* 3* 4 5 6 6a 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 26 14 Part No.
A.J WELLS & SONS LTD Bishops Way, Newport, Isle of Wight PO30 5WS, United Kingdom A Division of A.J.Wells & Sons Limited Registered in England No. 03809371 EN13240:2001 ROOMHEATERS FIRED BY SOLID FUEL EC certificate of conformity no: EY44-CPD-2006 Minimum distance to combustible materials: Side: Rear: 600 mm 700 mm Emission of CO in combustion products: 0.23% Flue gas temperature: 266°C Space heating thermal output: 4.8kW Energy efficiency: 76.
REV.COUNTRY 4 MKII v2 06.13 your premier dealer charnwood BISHOPS WAY, NEWPORT, ISLE OF WIGHT T: + 4 4 ( 0 ) 19 8 3 5 37 7 7 7 • F : + 4 4 ( 0 ) 19 8 3 5 37 7 8 8 • PO30 5WS, UNITED KINGDOM C O N TA C T U S AT W W W. C H A R N W O O D . C O M ® A D i v i s i o n o f A . J . We l l s & S o n s L i m i t e d Re g i s t e r e d i n E n g l a n d N o .
