Installation & Assembly

For Customer Service, contact the place of purchase to arrange for replacement parts.
7. Slip Canopy loop collar (H) over the chain, then do the
same with the canopy (G).
8. When ready to complete the installation Use the other
chain connector and attach the other end of the chain to the
canopy loop (F) and close the chain connector.
9. Make sure the weight of the chandelier will be supported
by the chain-not the electrical wire.
* You may now install the fixture.
4. By measuring determine correct number of links needed
for proper hanging height. Use a pair of pliers to open one
link of the Chain (K) then remove the excess Chain (K) and
discard it.
5. Use one chain connector (L) to attach one end of the chain
to the Top loop (J) and close the chain connector.
6. Feed the fixture wires through the Chain (every three links)
and pull the wires until taut.
Fig. 2
Note: Complete these remaining steps after the fixture is
hung.
10. Attach hook both ends of the Decorative Chain (N) to
Frame (M) as shown in the diagram.
11. Install the light bulbs (not provided) in accordance with
the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
PARTS & ASSEMBLY SHEET
C
D
O
b
b
a
a
Bulb
(Not Provided)
M
Nx3pcs
ASSEMBLING THE FIXTURE (Fig. 2)
4. By measuring determine correct number of links
needed for proper hanging height. Use a pair of pliers
to open one link of the Chain (K) then remove the
excess Chain (K) and discard it.
5. Use one chain connector (L) to attach one end of
the chain to the Top loop (J) and close the chain
connector.
6. Feed the fixture wires through the Chain (every
three links) and pull the wires until taut.
7. Slip Canopy loop collar (H) over the chain, then do
the same with the canopy (G).
8. When ready to complete the installation Use the
other chain connector and attach the other end of the
chain to the canopy loop (F) and close the chain
connector.
9. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
10. Attach hook both ends of the Decorative Chain
(N) to Frame (M) as shown in the diagram.
11. Attach ring of the crystal ball (O) to decorative
chain at bottom center of Frame (M) as shown in the
diagram.
12. Install the light bulbs (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
Optional:
Carefully clip the Fabric Shade (SHADE onto the bulb
Pearl Chiffon Shades -3 pack available separately