Installation & Assembly

Canopy Wire Connectors Top Loop

1ea @5-5/8"X1-5/8" 3ea P4 Orange 1ea @3/8 x 50mm

Chain

Junction Box

Screw

Spring Washer

1ea 6ft x3.8mm 2ea 8/32" x 1" 1ea @15 x 2mm

Chain Connector Nipple

2ea @3X38mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 65mm

Mounting Strap

w/ ground screw

Hex Nut

1ea 3/4"X4" 2ea @3/8 x 3mm 3 pcs

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

Fig. 1

NOTE: INSTALL THE SHADE ASSEMBLY AFTER THE

FIXTURE IS HUNG.

PARTS & ASSEMBLY SHEET

Read and review installation instruction sheet before

assembling the fixture.

IXTURE

SSEMBLY

NSTRUCTIONS

This fixture assembled PO:__________ Date: ________

Canopy Loop

with Collar

ASSEMBLING THE FIXTURE (Fig. 1)

1. Feed the fixture wires through the Top loop (J) and pull

the wires until taut.

2. Then screw the Top Loop (J) to the threaded center

column of Frame (M) until tight.

3. Gently spread the arms until evenly spaced if arms are

packed closed.

Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

For Customer Service, contact the place of purchase to arrange for replacement parts.

Bulb

(Not Provided)

Decorative Chain

PAGE 1
PARTS & ASSEMBLY SHEET This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET ASSEMBLING THE FIXTURE (Fig. 2) Fig. 2 4. By measuring determine correct number of links needed D C By measuring determine links for4.proper hanging height. Use correct a pair ofnumber pliers toof open one needed for proper hanging height. Use a pair of pliers to open one link of the Chain (K) then remove the discard excessit.Chain (K) and discard it. link of the Chain (K) then remove the excess Chain (K) and Useone one chain connector to attach of chain 5.5.
PAGE 3
INSTALLATION INSTRUCTIONS For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig.1) HANGING THE FIXTURE (Fig. 1) Fig. 1 Carefully remove the new fixture from the carton thebag yellow 1.1.Carefully remove the new fixture from the carton and theand yellow that bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. holds all parts.