Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench assembling a specific product (with 1 being (chanced) easy and 5 being difficult). For some products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the dock or spring washer is placed between the larger flab washer and the head of the screw or boll. Some furniture comes with height adjustment knobs underneath pate eq.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. #2 x 1pc Headboard Leg Right #4 x pc Foot board #6 x 1pe Foot board Leg Left ng #8 x PCs Slat Parts List ren FT #1 x 1pc Headboard Meson? green IIe Headboard Leg Left 1pc .
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed. Hardware List #A x pecs Dowel M10 x 40mm #C x Apes Bolt 1/4" x #E x pecs Flat Washer #G x apes Wood Button @15.5 #1 x pests C8K M3.
#A X PCs Nate: Left and right is determined by facing the front of the headboard in its upright position, 1. insert a dowel {#4} into the top hole on each end of the headboard 2. Insert the other end of the dowels (#4) into the Make sure to insert the sides of the per-drilled holes along headboard (#1) into the designated the top of the right/left slots along the legs headboard legs #2 AAA SA AbD #B x PCs #C x dos #D x sped #E x apes #G x apes 1.
#A x PCs Mote: Left and right is determined by facing the front of the foot board in ts upright position, 1. Insert a dowel {#A) into the top hole on gate end of the foot board 2.
#1 x pests #J x PCs 1. Hook the ends of the side rails {#7} into the slots along the headboard/footboard legs. #H x Apes #4 2. Align the brackets {#1} to each rail end and footboard/headhoard, insert 4 screws (#1) into each bracket and secure using a Phillips screwdriver. 1. Insert the threaded ends of the slat support fees (#9) into the per-drilled holes along the sides of the slats 2. Insert a screw {#H) into each end of the slats Secure using a Phillips screwdriver.
