Installation & Assembly

B：Find out the screw holes on the wall.
First, mark the point at same height on the wall as L-shaped Metal Bracket (③) on
product. You can find these same points in two ways as below:
1.Move the Cabinet back to the wall ,make these points on the wall and product are at
same height
2.Measure the height of the Matel Bracket and the walll by ruler ,keep them are
accurately and same height.
(Caution:The Cabinet Restraint Strap(
④
) between Metal Backets on product and
(Caution:The Cabinet Restraint Strap(
④
) between Metal Backets on product and
wall should be within 3.5'' .)
Then fix one L-shaped Metal Bracket on the mark on wall by the 5cm Self Tapping
Screws(②).
Repeat this step to fix another Metal Bracket (③) on wall, as shown above.
④
3.5'
③
④
C: Move the Cabinet against the wall. Then pull the Cabinet Restraint Strap(④) through
two Metal Brackets(③) one by one, lock tight the Cabinet Restraint Strap(④), as shown
above.
Cabinet Restraint Device is installed and Cabinet is ready for use.
③
Page 4 OF 5