Installation & Assembly

ManualsBrandsCharlton Home ManualsFour Person Patio Dining SetsRound 4 - Person 47.25'' Long Dining Set with Cushions

Assembly Instructions

CHAIR

Caution: You must read this before you proceed

CAUTION : This Chair is NOT a TOY.

Keep your child / children at bay during the assembly process.

For turning the Chair and to prevent damage to the Chair, 02 persons may be needed

to execute this action.

ctions

1/7

Summary of content (7 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed CHAIR CAUTION : This Chair is NOT a TOY. Keep your child / children at bay during the assembly process. For turning the Chair and to prevent damage to the Chair, 02 persons may be needed to execute this action.
PAGE 2
Parts List No. Picture Description QTY A Backrest Panel 1 B Right Leg Panel 1 C Left Leg Panel 1 D Seat Panel 1 E Seat Cushion 1 Description QTY ① Allen Key 1 ② Screw (M6*60mm) 7 Hardware No.
PAGE 3
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Backrest Panel (A) Right Leg Panel (B) Left Leg Panel (C) Seat Cushion (E) Seat Panel (D) Front Facing This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Unpack and place all parts on a clean, non-marring surface. 2.1) Align Backrest Panel (A) and Seat Panel (D) onto Left Leg Panel (C) as shown above. 2.2) Align Right Leg Panel (B) onto Backrest Panel (A) and Seat Panel (D) as pictured.
PAGE 5
Attach Right Leg Panel (B) to Seat Panel (D) and Backrest Panel (A) by using 3 Screws (②) with Allen Key (①). Do not fully tighten the Screws. Carefully turn the Chair over. Attach Left Leg Panel (C) to Seat Panel (D) and Backrest Panel (A) by using 3 Screws (②) with Allen Key (①). Do not fully tighten the Screws.
PAGE 6
Step 5 Place the Chair onto a level surface, then carefully sit onto the Chair. This pressure will help the Chair reach full alignment at all joints. In a sequential manner, gradually tighten all Screws until evenly secured. Inspect the Chair and make sure all parts are adequately connected. Step 6 Place Seat Cushion (E) onto the Chair. Lay the Chair down and tie the velcro straps of the Cushion (E) to the Seat Panel (D) as shown above. Your Chair is ready for use.
PAGE 7
/7