Instruction Manual

ManualsBrandsCharlton Home ManualsDusk to Dawn Post LightsAlmonte 2-Light LED 90" Lantern Head

Introduction

Thank you for your purchase. Our solar charged accent lighting eliminates the problems

associated with most solar lighting available today. Our solar charged lights are brighter

and last all night with a typical solar charge. Unique design, superior light output and

numerous installation options confirm the outstanding value of the product.

Instruction Manual

US Patent # 7172307

SOLAR LAMP

The company also offers unique multi-purpose rechargeable products that rangefrom

party lights to emergency lighting products.

For technical assistance and more information call our Toll Free number or visit our

website.

Summary of content (5 pages)

PAGE 1
SOLAR LAMP US Patent # 7172307 Instruction Manual Introduction Thank you for your purchase. Our solar charged accent lighting eliminates the problems associated with most solar lighting available today. Our solar charged lights are brighter and last all night with a typical solar charge. Unique design, superior light output and numerous installation options confirm the outstanding value of the product.
PAGE 2
Please read the instruction manual carefully to obtain the best results from your purchase. Unpack and identify the following components.
PAGE 3
Tools that are needed but not supplied with the high post solar lamp set are: a screw driver, a wrench and an electrical drill that will be used to anchor the lamp base to the ground. Solar Lamp Post Location For optimum light duration throughout the night, it is very important to mount your solar lamp post in a spot where it will receive the maximum amount of direct sunlight throughout the day. Assembly Instructions NOTE: The following steps are for reference only.
PAGE 4
1. Repeat steps 1 to 6. 2. Screw part (D) to part (E). part (C) to part (D) and part (H) into part (C). 3. Screw bracket (J) into part (H) using the provided screws as shown in Fig. 3. 4. Repeat step 3, two times and three times. 5. Screw part (K) on top of part (H) or (I) . Fig. 3 Replacing the Batteries (After several years of use, the batteries may need replacing). 1. Remove the top (A) from the fixture (B) by releasing the 2 screws (Fig. 2). 2. Make sure the ON/OFF switch is in the “OFF” position. 3.
PAGE 5
Maintenance Clean the solar module regularly with a damp towel to guarantee optimum performance of the solar panel. Do not use any type of solvent for cleaning and be careful not to put too much pressure on the module while cleaning. Trouble Shooting If your solar charged light does not come on at dusk despite observance of all the instructions, please try the following steps: 1. Make sure that the solar light is not being affected by any other light source. 2.