Instruction Manual

Tools needed:

Tools that are needed but not supplied with the solar lamp post set are: a screw

driver, a wrench and an electrical drill that will be used to anchor the lamp base to the

ground.

Solar Lamp Post Location

For optimum light duration throughout the night, it is very important to mount your

solar lamp post in a spot where it will receive the maximum amount of direct sunlight

throughout the day.

Assembly Instructions

NOTE: The following steps are for reference only. Consult your local hardware

store for the best installation method for your particular surface.

1. Turn the On/Off switch on the lamp head (A) to Low or High position

(Fig. 1).

3. Put the fastening screws (G) into the drilled holes with their threaded

ends facing up.

4. Place lamp base onto fastening screws and secure base with the nuts

using a wrench. Cover the bolts with the plastic covers provided.

5. Make sure the lamp base (F) is stable before installing Part (E).

Fig. 1

2. Use electric drill to make three holes into a solid surface no smaller

than the fastening screws (G). The holes shall be lined up with the

holes of the lamp base (F).

NOTE: For installation in the ground where pouring concrete is

not preferred or possible, use our Lamp Post Anchor (sold

separately) to quickly and easily secure the lamp anywhere in

your yard.

WARNING: These Light bulbs are not to be used in other electrical sockets

these are low-voltage light bulbs that are built and designed for our products

only!

NOTE: The solar light must be charged for two sunny days in the “On” position

for best results.