Instruction Manual

After assembling your specific bracket here are the steps to finish assembling your unit,

this step applies to all three brackets:

Replacing the Batteries

(After several years of use, the battery may need replacing).

1. Unscrew the two screw caps and detach the top (B). Make sure the ON/OFF

switch is in the OFF(O) position.

2. Unscrew the battery compartment (Fig.5) screw located on the silver reflector

and remove the compartment door.

4. Clip on new battery and install into the battery compartment. Screw back battery

compartment screw.

5. Reattach the top and secure with the 2 screw caps.

1. Place the lens and cone (C) in the body (D).

2. Turn on switch to desired setting.

3. Attach top(B) to the body(D) with

the two supplied screw caps.

6. Screw on top ornament.

Fig.5

** Batteries are available at our website.

3. Unclip the connector and remove the old battery. Make sure the new battery is a

3.2V/1,500mAh, Li-ion Rechargeable battery with connector.