Instruction Manual

Assembly Instructions:

Note: If you are replacing an existing gas/electric post light, you must consult a certified technician to

disconnect them before installation.

Note: There are specific types of screws for specific surfaces. If unsure of the appropriate type of screw

to use on your desired surface, please consult a professional.

1. Use a drill to make two holes in the desired surface.

2. Place the screw anchors into the holes, place the lamp in line with the holes and secure

with the provided screws.

3. Attach the base (H) to the Pier Mount (G) with the nut (Fig.1).

4. Attach the fixture (D) to the base (H) with the four supplied screws, as shown (Fig.2).

Note: Make sure lamp is mounted so full sun exposure is possible.

1. Use a drill to make two holes in the desired surface.

2. Place the screw anchors into the holes, place the lamp in line with the holes and secure

with the provided screws.

3. Attach the base (H) to the Wall bracket (F) with the nut (Fig.3).

4. Attach the fixture (D) to the base (H) with the four supplied screws, as shown (Fig.4).

1. Attach the fixture (D) to the base (H) with the

four supplied screws, as shown.

Fig.1

Fig.2

Fig.3

Fig.4