Assembly Instruction

ASSEMBLY INSTRUCTION
※ Installations for hanging pendant
1. Carefully unpack the fixture, lay out all parts on a clean surface.
2. Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws.
3. Fasten the loop to the nipple A. Fill holes of the canopy B with the Screws and Lock Nuts provided in the
pendant hardware kits.
4. Screw the nipple B into the bushing, screw the nipple C into the tube A, screw the tube B into nipple D.
5. Using two pliers, twist open links at two ends of the chain as show. Hook one link to the loop and the other link
to the screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and the chain link to
prevent scratching the link finish.
6. Weave fixture wires up through the loop, through the chain, through the ring, through canopy A, through the
screw collar loop and through the nipple on the mounting strap.
7. Tie the ground wires from fixture and from outlet box to the ground screw on the mounting strap. Connect the
wire without writing on it (with raised ribs) from the fixture to the white wire (neutral wire) from the supply
circuit. Connect the wire with writing on it from the fixture to the black wire (live wire) from the supply circuit.
Cover the connections using provided wire connectors. Position wires back inside outlet box.
8. Place the canopy A over the nipple all the way to the ceiling and tighten the ring onto the screw collar loop
until the canopy A is held firmly against the ceiling.
9. Unscrew the socket ring and socket cover from the socket. Place the shade A and shade B and socket cover
over the socket, refasten the socket ring to secure it.
10. Install the bulb (Not included). Turn on the power.