Assembly and Installation Instructions

ManualsBrandsCharlton Home ManualsCeiling LightsSarmiento 1 - Light Single Cone Pendant

1. Rod Connections:

a. Thread the fixture wire from the fixture through the lower rod, and then

secure the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure the

middle rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure the

upper rod onto the middle rod using the threaded pipe.

Note: Length adjustable from 11-1/2" to 53-1/2". Use fewer

rods if shorter length is desired.

Thread the fixture wire through the canopy kit, and then secure the

rod assembly to the set nipple of the canopy kit.

3. Attach the mounting strap to the outlet box by using two mounting screws.

4. Pull out the source wires from the outlet box. Make wire connections

using wire nuts as follows:

---Connect the smooth-coated wire (marked) from the fixture to the

black wire from the power source.

---Connect the ribbed-coated wire (unmarked) from the fixture to the

white wire from the power source.

---Attach the fixture grounding wire to the mounting strap with the

green grounding screw, and then connect it to the house grounding

wire with a wire nut.

Carefully put the wires back into the outlet box.

5. Attach the canopy kit to the mounting strap by inserting the fixture

mounting screws, and then secure it with two ball nuts.

6. Attach the glass shade to the fixture, and then secure it with the socket ring.

7. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THIS INSTRUCTION.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Mounting Screw (C)

Lock Nut (F)

Wire Nut (E)

Mounting Strap (A)

Fixture Mounting

Screw (D)

Green Grounding

Screw (B)

Canopy Kit

Outlet Box

House Grounding Wire

Wire Nut (E)

Lock Nut(F)

Mounting Strap (A)

Green Grounding Screw (B)

Mounting Screw (C)

Upper Rod

Middle Rod

Lower Rod

Socket

Fixture

Glass Shade

Socket Ring

Threaded Pipe

Fixture Wire

Fixture Mounting Screw(D)

Fixture Grounding Wire

Bulb Type A Max.100W

(Not Included)

Set Nipple

Ball Nut(G)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THIS INSTRUCTION.
PAGE 2
8. Angled mounting recommended for a vaulted or angled ceiling. (See Fig. 1) Turn on the power at fuse or circuit box. Fig. 1 Support Brace Outlet Box Canopy Coupling Kit The following parts are available for re-order if damaged or missing.