Installation & Assembly

page 2
Assembly Instructions
STEP 1
Route the electrical wire from the power supply
underground and out through the middle of the
installation area. Screw the anchor bolts into the
mounting unit. Fill the hole with concrete (not
included) and insert the assembled mounting unit
before the concrete dries. The mounting unit
should be at ground level.
STEP 2
Connect the positive, negative and ground wires with the
supplied wire nuts. Secure with electrical tape
STEP 3
Secure the base to the mounting unit and attach the pole
to the top of the base. Attach the fixture to the pole, install a
bulb (not included), and secure the fixture top.
Connect Clear, Brown, Gold or
Black Parallel Wire without tracer
(round & smooth) or Black Fixture
Wire to:
Black or Red Supply Wire or
Insulated Wire (other than green)
with copper conductor.
Connect Clear, Brown, Gold or
Black *Parallel Wire with tracer
(square & ridged) or White Fixture
Wire to:
White Supply Wire or Insulated
Wire (other than green) with silver
conductor
Copper
Silver
Smooth
Ridged
POST LIGHT