Assembly Instructions
12
2
3
M
N
O
P
L
J
4. Attach the left and right front legs (M&N) to seat frame (L) using
4 spring washers (2), 4 flat washers (3), and 4 hex nuts (12) as shown.
Do not tighten at this point.
5. Insert the front crossbar (O) into the oval holes of left and right front
legs (M&N) as shown. The small holes on the edge of the
crossbar need to face towards the bottom of the leg.
6. Insert side crossbars (P) into the round holes of left and right front
legs (M&N) and back frame (J). The small holes on the bottom
of the crossbars must face the bottom of the chair.
19
Diagram #3
REQUIRED HARDWARE IN THIS STEP
NO.
DESCRIPTION SKETCH
QTY
3
2
12
FLAT WASHER
SPRING WASHER
HEX NUT
4
4
4
14
OPEN END WRENCH
1
CHAIR ASSEMBLY INSTRUCTIONS