Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the
installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker and remove old fixture,
including the single bar. Carefully unpack your new fixture and lay
out all the parts on a clear area. Take care not to lose any small
parts necessary for installation.
2. Thread the two mounting screws into the pre-drilled holes in the
crossbar, spaced about the same distance apart as the holes in the
fixture back plate. Attach the crossbar to the junction box using two
junction box screws as shown. The side of the mounting plate
marked “GND” must face out. The junction box is not included.
3. Follow wiring instructions carefully .(see fig.2)
4. Attach the lamp body (A) onto the junction box, aligning screws on
crossbar with mounting holes and lock it securely with the ball nuts
(C). Put the candle sleeve (B) over the lamp holder.
5. Install the light bulbs (Not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
6. With silicone caulking compound, caulk completely around
where back of cover meets with the wall surface to prevent
water from seeping into junction box.
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from
the fixture to the black house (hot) Wire. Connect the white wire from
the fixture to the white (neutral) house wire. Make sure all wire nuts
are secured. You may wrap the connections with electrical tape. If
your outlet box has a ground wires (green or bare copper) connect
fixture’s ground wire to it. Otherwise attach the bare copper fixture
wire to the green ground screw on the crossbar.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction
box and test the fixture.
A
B
Fixture wire
Fixture ground wire
Box screw
Crossbar
Supply ground wire
Mounting screw
Junction box(Not included)
Supply wire
Hex nut
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
FIG.2
FIG.1