Installation & Assembly

E
Wood Screw
Head Cap Bolt
Spring Washer
Flat Washer
Assembly Instructions 2/3
IMPORTANT
Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.
Do not tighten all the bolts and wood screws until each part is properly assembled.
Keep Hex Wrench in a safe place as the bolts may need to be tightened up in the future.
STEP 1
Attach Legs (D) and (E) to Seat (A) with Flat Washers,
Spring Washers and Head Cap Bolts, tightening
the bolts only half way.
(See Figure 1)
Attach Side Stretcher (B) to Leg (D) with Wood Screw.
(See Figure 2)
Slide the ends of Center Stretcher (C) into the pre-drilled holes
in the middle of Side Stretchers (B).
(See Figure 3)
Attach Side Stretcher (B) to Leg (E) with Wood Screw.
Figure 1
Figure 2
Figure 3
B
B
C
D
E
A