ASSEMBLY INSTRUCTIONS Console Table NOTE TO CUSTOMERS: o For ease and speed of assembly we recommend that before you commence each step of the assembly that you identify all the parts required to complete that step. * We recommend that where possible you allow sufficient space to assemble the item as close as possible to the place where it will be once assembled. o For the protection of your furniture we recommend that the product is placed on protected surfaces during assembly to prevent any damage.
To insert a cam lock: (Please read below instructions before assembling) I Diagram Diagram Insert cam screw into hole as shown in diagram A . Make sure not to insert the cam screw: Too deep as shown in figure B as this will cause the cam screw to be misaligned and unable to interlock properly. Also avoid inserting the cam screw too close to the surface of the hole as shown in figure C, as this will cause the cam lock to be too loose, and not interlock properly. 2. Connect the panels together.
1 WARNING: Serious or fatal crushing injuries can occur from furniture tip-over. To help prevent tip-over: o Place heaviest item in the lowest drawers. * Unless specifically designed to accommodate,do not set TVs or other heavy objects on top of this product. Never allow children to climb or hang on drawers, doors or shelves. Never open more than one drawer at a + Do not defeat or remove the drawer interlock system. Use of tip-over restraints may only reduce,but not eliminate the risk of tip-over.
APPENDIX: Dimension of Hardware in this Wood Dowel Cam-tilt Cam-Lock Loren Screw & Bolt Screw Screw Ta — STEP 1 B1 e= PCs B2 «72 & {set B4 go PCs Assemble Cross Bar A10 and Shelf Panel A4 to Divider AS using Wood Dowels B1, Cam locks B2 and Screws B4 as shown above.
B1 z= PCs B2 «3s & Sets B5 ®& headsets Assemble Side Panels to Bottom Panel AS, Shelf Panel A4, Cross Bar A10 using Wood Dowels B1, Bolts with washers BS and Cam locks B2 as shown above. STEP 3 Bl == poss B2 a2 & sets B7 PCs Assemble Top Panel Al to Side Panels ,Cross Bar A10 and Divider A7 using Wood Dowels B1 ,Cam locks B2 and Screws B7 as shown above.
STEP 4 B6 OL posts STEP 5 B3 sets BAS B4 PCs 1). Assemble Drawer Side Panels to Drawer Back Panel A8 using Screws B4. 2). Insert Drawer Bottom Panel A9 into the grooves on the Drawer Side Panels Drawer Back Panel AS. 3). Assemble Drawer Front Panel A6 to Drawer Side Panels A7 (L&R) using Screws B4. 4). Attach Drawer Handle B3 to Drawer Front Panel A6 using included screws. 5). Repeat above steps to assemble the other drawer.
STEP 6 Insert Drawers into the table as shown above. STEP 7 BS ao x#1set B9 go 1st For your safety, please attach the table to the wall using Anchor with screw B8 and Anti-tip Kit B9 as shown above.
