Installation & Assembly

ManualsBrandsCharlton Home ManualsCeiling LightsMargaret 5-Light Shaded Classic / Traditional Chandelier

CHANDELIER

TOOLS AND MATERIALS REQUIRED:

Phillips

Screwdriver

Wire Cutters

Pliers Wrench

Wiring supplies

as required by

the Canadian

Electrical Code

and/or the

Quebec

Electrical code

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS

READ ALL INSTRUCTIONS

IMPORTANT SAFETY

INSTRUCTIONS

SAVE THESE INSTRUCTIONS

Step 2

Step 1

Step 3

Loop

Power

Cord

Chain

Lower

Connector

Nipple

Hex Nut

Outlet Box

Outlet Box Screws

(not included)

Mounting

Bracket

Attach the mounting bracket to the outlet box using electrical

box screws (not included) . Attach the nipple to the mounting

bracket and adjust until it will clear the canopy when assembled

(Place the canopy over the nipple and tighten the upper

connector onto the nipple until snug. The upper connector

should hold the canopy snug to the ceiling). Lock the nipple in

the correct position using the hex nut.

To attach chain loop to light fixture, use a screwdriver and wrench

to open and close chain loop. Ensure to close the opening.

Weave the power cord and ground wire through the links in the

chain.

Spread the arms evenly.

Tighten the loop to the stem on the canopy.

INSTALLATION:

SAFETY PRECAUTIONS:

1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.

2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE

BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE

HAZARDS INVOLVED.

3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND

WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.

NOTE: Product May Not Look Exactly As Shown In Figures.

Summary of content (2 pages)

PAGE 1
CHANDELIER ! INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS TOOLS AND MATERIALS REQUIRED: IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS SAFETY PRECAUTIONS: Phillips Screwdriver Wire Cutters Pliers Wrench Wiring supplies as required by the Canadian Electrical Code and/or the Quebec Electrical code 1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE. 2.
PAGE 2
Step 4 2 1 Step 5 Loosen the nut on the upper connector and slide it down the chain towards the lower connector. Slide the canopy down the chain towards the lower connector. Feed the wire through nut, canopy, the upper connector and onto the nipple. Tighten the upper connector onto the nipple. Spread the other end of the chain open and fasten to the upper connector. Ensure the opening is closed.