Assembly Guide

TOOLS

• Heavy duty hammer

• Level

• Flathead screwdriver or pliers

• Small block of wood

COMPONENTS

Part Description Qty

(A) Lamppost 1

(B) Metal ground stake (no dig) 1

STEP 1

Install metal ground stake

Measure and mark the half way point on Metal ground stake (B) as shown in Figure

1 below. Place Stake (B) in desired location and carefully use a hammer to drive it

into ground. Use level to make sure the stake is straight and plumb. Adjust as needed

and ﬁ nish driving it into the ground using a small block of wood on top of stake as

shown in Figure 2 below. Install no deeper than the half-way point.

Fig. #1

Fig. #2

Before you start

IMPORTANT Check for underground services with your local

authorities BEFORE installation of this product. They will

typically mark out underground cables/gas etc at no charge.

Lamppost

This lamppost is pre-assembled and comes with a stable top “shelf” that allows you to

mount any type of lamp/lantern (whether directly into the lamppost neck or by using any

mounting bracket that the lamp would come with).

Your lamppost can carry wiring to the lamp – please use a standard wood-drill bit in order

to slowly and carefully put a hole in the ﬂ at-top of the lamppost. The wiring that you use

should be fully shielded… no exposed wires. Thread the wiring through from the ground,

up through your lamppost and then out of the hole that you have drilled in the top and into

the lamp. Note that your lamppost has a ﬂ at top in order to allow you to either (a) attach a

lamp directly to the shelf (screw down into the top) OR (b) attach an adapter which will

then receive your chosen lamp.

ASSEMBLY GUIDE

PAGE 1
ASSEMBLY GUIDE Lamppost Before you start TOOLS • • • • IMPORTANT Check for underground services with your local authorities BEFORE installation of this product. They will typically mark out underground cables/gas etc at no charge.
PAGE 2
STEP 2 STEP 4 Set ground stake tabs into place Final adjustment Use a ﬂat head screwdriver and/or a set of pliers to bend the locking tabs on Metal ground stake (B) into appropriately a 45 degree angle as shown in Figure 3. 45˚ Final adjustment may require you to twist the post and ground stake so the Lamppost (A) is positioned in the correct direction. This rotation adjustment will not disrupt the ground attachment of the stake. Fig. #3 Fig.