Installation & Assembly

PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on
a clear area. Be careful not to lose any small parts necessary for
installation.
CONNECTING THE WIRES (Fig. 2)
3. Connect the xture wires to junction box wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect the
xture’s ground wire directly to the mounting plate (D1) using
the green screw provided. After wires are connected, tuck
them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
4. Secure the mounting plate (D1) to the junction box (F1)
using the junction box screws (B1).The side of the
mounting plate marked “GND” must face out.
5. Thread the long screw (G1) into the holes (spacing 2-3/4”)
in the mounting plate (D1).
Keep enough length for xture (I1) installation.
MOUNTING THE FIXTURE (Fig. 1)
6. Place the xture (I1) over the mounting plate (D1).
Twist the xture (I1), secure at the key holes using the
long screw (G1).
7. Thread the nipple (C1) into the hickey at the xture (I1).
Adjust the hex nut (M1) to t the end nial (E1).
8. Place the glass (H1) onto the xture (I1), secure with the
rubber washer (L1), the metal washer (K1) and the hex nut (J1).
9. Fasten the end nial (E1) onto the nipple (C1). Make sure
the end nial (E1), the metal washer (K1) and the glass (H1) is
aligned.
10. Secure using Allen screw (P1) and Allen wrench (N1).
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
F1
A1
D1
B1
G1
I1
M1
C1
H1
L1
K1
J1
E1
P1
N1
FIG.1
Junction box
Wire connectors
mounting plate
Junction box screw
long screw
xture
Hex nut
Nipple
glass
Rubber washer
Metal washer
Hex nut
end nial
Allen screw
Allen wrench
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
INSTALLATION INSTRUCTION