ASSEMBLY INSTRUCTIONS Description Dimension Cube Size : X-BACK PUB BAR STOOL WITH MICROFIBER UPHOLSTERED : W.18"x D.21"x H.39"1/2 : 42”x18.2”x11.2” NW: 30.8 LBS GW: 35.
BEFORE ASSEMBLY Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take the time to read and follow the assembly instructions carefully. Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please separate, identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: NO Description Qty Sketch NO Long bolt 1 Description 4 (M6x80mm) (M6x60mm) Short bolt Lock Washer 4 2 10 (Ф6.5x9) (M6x40mm) Flat Washer 5 Sketch Medium bolt 2 4 3 Qty Allen Key 6 10 1 (Ф6.5x19) (4mm) Screw 7 6 (M4x40mm) STEP 1 Attach frame (B) to the back (A) by using bolts (3) and (1) and washers (4) and (5).
STEP 2 Attach front legs (C-L) and (C-R) to the seat frame. Use bolts (2), washers (4) and (5) .Tighten with Allen Key (6). Place front stretcher (E), side stretchers (D-L) and (D-R) between front and back legs, use the screw driver to tighten the screws (7) as shown below. Note: DO NOT tighten any of the bolts, until Place front stretcher (E), side stretchers (D-L) and (D-R) between front and back legs the chair is assembled, then tighten the bolts and the screws.
