Measurement Guide

PO BOX 35430 CHARLOTTE, NORTH CAROLINA 28235
SALES PHONE [phone] [phone]
TECHNICAL PHONE [phone] FAX [phone]
WWW.CHARLOTTEPIPE.COM
PDS-PVC-2729-PIPE-220
Possession of this product data sheet shall not be construed as an offer to sell the products listed.
“You can’t beat the system” is a registered trademark of Charlotte Pipe and Foundry Company.
© 2019-2020 Charlotte Pipe and Foundry Company.
Product Data Sheet PVC-2729-PIPE-220
Effective February 28, 2020
Supersedes Product Data Sheet
PVC-2729-PIPE-319
PVC Sewer and Drain Pipe
• NEVER test with or transport/store
compressed air or gas in PVC / ABS /
CPVC / Cast Iron pipe or fittings.
• NEVER test PVC / ABS / CPVC / Cast
Iron pipe or fittings with compressed
air or gas, or air over water boosters.
• ONLY use PVC / ABS / CPVC / Cast Iron
pipe or fittings for water or approved
chemicals.
• Refer to warnings on PPFA’s website
and ASTM D 1785.
Testing with or use of compressed air or gas in PVC / ABS
/ CPVC / Cast Iron pipe or fittings can result in explosive
failures and cause severe injury or death.
NOT FOR PRESSURE
Do not use PVC Sewer pipe for pressure applications. The
use of sewer pipe in pressure applications may result in
system failure and property damage.
Perforated pipe is supplied with two rows of 1/2” diameter holes every five inches. Rows are parallel to the pipe
axis and are 120° apart.
Weight is approximate and is for shipping purposes only.
Pipe listed in this section meets or exceeds the requirements of ASTM D 2729.
PVC 30030 3 ” x10’ 10903 810’ 3.250 0.070 3.00 52.8
PVC 30040 4 ” x10’ 10905 500’ 4.215 0.075 3.50 70.4
PVC 30060 6 ” x10’ 15149 330’ 6.275 0.100 4.00 129.0
>> PVC ASTM D 2729 Pipe
SOLVENT WELD BELLED END ASTM D 2729
PART NO. NOM. SIZE UPC # QTY. PER AVG. OD (IN.) MIN. WALL (IN.) BELL DEPTH WT. PER
611942- SKID (IN.) 100 FT. (LBS.)
PVC 30030P 3 ” x10’ 11814 1040’ 3.250 0.070 3.00 52.8
PVC 30040P 4 ” x10’ 11815 500’ 4.215 0.075 3.50 70.4
>> Perforated PVC ASTM D 2729 Pipe
SOLVENT WELD BELLED END ASTM D 2729
PART NO. NOM. SIZE UPC # QTY. PER AVG. OD (IN.) MIN. WALL (IN.) BELL DEPTH WT. PER
611942- SKID (IN.) 100 FT. (LBS.)
All products manufactured by Charlotte Pipe and
Foundry Company are proudly made in the U.S.A.