User`s guide

Section 360−381−S02
33
7.1.9. 1 kHz 0dbm0 Test Tone
During this test a continuous tone is present until released. Use the following steps to perform the test.
Step Action System Response
1. Select Loopback Test " 1KHz 0dbm0 Test
Tone
If multiple voice cards are installed, asks you to
select which one you want to test. Go to step 2.
Otherwise, opens the 1 KHz 0dbm0 Test Tone dia-
log box (see Figure 28). Go to step 3.
2. Select the card you want to test and click OK Opens the 1 KHz 0dbm0 Test Tone dialog box
(see Figure 28).
3. Select the Operation or Release tab.
4. Check the box beside the channel number you are
testing.
5. Select the direction (XMT or RCV).
Note: XMT is toward the T1.
6. Select OK Initiates the test or release.
Figure 28. 1KHz 0dbm0 Test Tone
7.2 Performance
The performance monitor gathers and displays the performance history of the system over a 30-day period. Er-
rored seconds (ES), severely-errored seconds (SES), and failed seconds (FS) are displayed graphically in
15-minute or 1-day intervals.
7.2.1. One Day PM Data
Use the following steps to look at one day of PM data:
Step Action System Response
1. Select Performance " One Day PM Data Opens the One-Day PM data screen with no data
displayed.
2. Select whether you want to check today’s data or
a previous day’s data.