User`s guide

Section 360−381−S02

2.2 Installing the Software

Use the following steps to install the software:

Step Action

1. Insert the CD containing the NMS software into your CD drive.

2. From the Windows start menu, select Run and type in X:\SETUP (where X is your CD drive letter).

3. Follow the prompts to continue installation.

2.3 Connecting the PC to the ICB

Use the following steps connect the PC to the ICB:

Step Action

1. Using the craft interface, set the ICB’s IP address. To allow remote access outside the ICB’s LAN, the

gateway address should be set to the IP address of the LAN’s router. See the Craft Interface documen-

tation for additional information.

2. Connect the ICB to the PC/LAN using an Ethernet cable to the J2 rear panel network management

port.

Note: To connect multiple ICBs see the procedure in the T1 Controller with SNMP (3603-81) documentation.

2.4 Starting the Software

Use the following steps to start the software and log in to the system:

Step Action System Response

1. Select Start Menu " Programs " Charles "

NMSmgr

Opens the NMS main screen (see Figure 1).

2. Select Setup " Supervisor Log In Opens the following dialog box:

3. Enter the default password 123 to log in. You are logged in as a supervisor, and have ac-

cess to all menu options.

Note: The Supervisor password should be changed as soon as possible. See the section in this manual on

Configuring the System.